Publishing to our FrontPage Web Server

 The Imagen webservers have Front Page Extensions installed.

In order to properly publish your FrontPage web site to our server, you must follow these instructions to the letter, the first time.  For detailed instructions click here.

Before attempting to publish your FrontPage web please verify that you can access your web site on our server.  For instructions on accessing your site on our server click here.  It is also a good idea to remove the web publishing wizard, click here for instructions.

Basic Instructions

1. Connect to the Internet.
2. On your computer open the web site that you wish to publish.
3. Click File, Publish FrontPage Web
   Do not click the Publish button in the Toolbar of FrontPage Explorer.
4. Click More Webs.
5. Enter your web site address in its entirity.  ie. http://www.saltspring.com/test
   If you don't know it click here.
6. Enter your username and password
   If you don't know your username click here, your password click here.
7. Done, from now on you can click the Publish button found on the Toolbar of FrontPage Explorer.

Detailed Instructions

Step 1:  Connect to the Internet

The first thing to do is connect to the internet.

Step 2:  Open your local web site

The default location for starting FP98 is "Start, Programs, Microsoft Front Page."   Previous versions of FP created their own folders on the start menu so look for that if the above does not apply.  Either way it should be pretty self explanatory on how to launch FP.

Step 3:  Start the Publish

Once you've opened the site you want to publish to our server, click File, Publish FrontPage Web and then click More Webs.  Do not click the Publish button in the Toolbar of FrontPage Explorer.

Click More Webs.

In this step you will enter the Url of your web site.  In this case the Url is "http://www.saltspring.com/
capturetest."  Once you've entered the address click OK.

The last step is to enter your "Username and Password."  This is the same username and password that you use to access the internet for dialup, mail and ftp.  In this case "anu."  After entering the proper information click "OK."  Once you've entered the proper username and password and the site has been published, you should see a screen similar to the one below.

TIP:  You can verify that you've correctly published to the right location by looking at the address in the bottom left hand corner of the screen.  In this case "http://www.saltspring.com/capturetest.".

For more information see the following Microsoft article: "FP2000: How to Publish a FrontPage Web"